NA/NB Miata MagSafe Vent Phone Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A magsafe phone mount(iPhone 14 Pro) for NA & NB Miatas air vents
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 54
- Wydruki
- 0
- Wyświetlenia
- 848
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted to make something that wouldn't take up room on the dash/windshield area and also mount relatively close to me. The holder is meant to replace the middle pod on the passenger side and is angled towards the driver(The phone can be turned horizontally and is spaced just enough to clear the dash). The gaps in the dash make it so you can route the cable inside and plug into a rear radio usb to power it.
I recommend you print this in ASA since it will be receiving full sun at all times of the day. My print settings were 25% infill with 3 perimeters, snug supports and also with a brim just in case.