Sofa Table and Cup Holder (Adaptable but made for IKEA FRIHETEN couch)

This is a table and cup holder that fits the Ikea Friheten sectional couch and sleeper perfectly. I made this to hold my plates and drinks while sitting on the couch. Printed for some friends and they also loved using it so thought I would share it here. The cup holder was sized to fit Ikea tall glasses, beer glasses and tumbler glasses (although they tend to vary quite a bit in size so not all glasses I have fit the same).

There are some dovetail slots in the model that allow for additional spacers to be added for other couches or for improving the stability and angle of the table on the Ikea Friheten. I have not any spacers as I did not end up needing them but they should be relatively straight forward to design.

I originally printed this in ABS because I wanted to have some resistance to hot mugs of tea or coffee but I have found that the difficulty in printing ABS is not worth the effort and PLA works fine for most drinks (as long as hot plates or mugs are not used for long or cool down relatively fast).

I printed this with standard 0.2mm settings on a Bambu Labs X1C. Make sure to set the bottom shell layers to 4 or more as this will be the top surface of the table.

The infill setting and wall loops count are not too critical but I would stay at 2 wall loops or more and perhaps use gyroid or hex fill for strength, although this will take a while to print. Triangle-hex fill or triangles fill is ok to improve print speed considering the large volume. Fill volume of 10% should be sufficient but can go higher for more heft (but longer print time).