Portable soldering Station for KSGER STM32 OLED V2.01 T12
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I needed a portable case for my soldering station do solder LED stripes on the go. I had a controller laying around…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 591
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
I needed a portable case for my soldering station do solder LED stripes on the go.
I had a controller laying around and some 3S LiPos, so I came up with this design.
You will need:
- KSGER STM32 OLED V2.01 Temperature Controller (AliExpress: https://bit.ly/3o0YU6r)
- 3S LiPo 11.1V/30C/3000mAh (I have this one from Gearbest: https://bit.ly/33i7shq)
---> Check the physical dimension of the LiPo! - XT60 Connector, Male (AliExpress: https://bit.ly/3fFtmA5)
- On/Off switch 15 mm*10 mm (AliExpress: https://bit.ly/3q5BJtH)
- Some wires
7 M3*30 mm screws To use it completely
T12 Handle (AliExpress: https://bit.ly/379PiQg)
T12 Tips (AliExpress: https://bit.ly/33lPRoG) I printed the middle part upside down, to have the ugly support interface side hidden in the inside.
Print Settings
Printer Brand:
Ultimaker
Printer:
Ultimaker 3 Extended
No
Supports:
Yes
0,2
Infill:
25%
Category: Tools