MG4 6.5" speaker adapter rings
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
speaker adapters used to install aftermarket 6.5" speakers
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 123
- Wydruki
- 0
- Wyświetlenia
- 675
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
speaker adapters used to install aftermarket 6.5" speakers,
I installed Audison prima 6.5s in all 4 corners of my xpower as well as sound deadening, Audison tweeters, prima AP8.9 amp and subwoofer,
I recommend using this type of foam tape, I used 10mm thick version and it was hard to get the door cards back on so I would use 8 or 6mm if I did it again:
https://www.amazon.co.uk/dp/B09Z6MY8DF?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_2&th=1
Also would be best to use some thin foam gasket between adapter and door to get a good seal
HIGHLY RECOMEND PRINTING IN ABS OR PETG (as it gets quite hot in the interior of cars and PLA probably wont hold up over time)