Dyson V8 Dust Bin Door Replacement
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Complete replacement for hinged dust bin door. Smaller replaceable parts for the hinge and clip.
- Ocena
- 5 / 5
- Polubienia
- 22
- Pobrania
- 241
- Wydruki
- 1
- Wyświetlenia
- 891
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Problem
I had the clip snap off of my Dyson V8 vacuum. Replacement doors are about 15 EUR on Amazon, so why not spend much more time developing a 3D printed replacement??
Materials
I've split the design into a few pieces with mechanical fasteners for two reasons:
- make removing support material easier, and
- make the parts likely to break, the hinge and clip, very small and easily re-printable
Hardware
To assemble the pieces, you will need
- 6x M3 hex nuts
- 6x M3x10 bolts (M3x8 worked for me, but it was a little tight)
- 1x Dyson v8 dust bin gasket (remove carefully from your broken door
Filament
I've printed the entire thing in PLA. Once the clip fails through fatigue, I'll print the replacement in PETG.
Printing Instructions
Lid Base
No support needed. I did 0.6mm nozzle, 0.4mm layer height, (Prusa DRAFT profile), 15% infill.
Gasket Base
Enable support material to the build plate. I did 0.6mm nozzle, 0.4mm layer height, (Prusa DRAFT profile), 15% infill.
Bolt Spacer
Can be orientated so that no support is needed. I did 0.6mm nozzle, 0.2mm layer height (Prusa DETAIL profile), 100% infill.
Clip
Paint on supports to the build plate for the unsupported inner diameter of the recessed bolt holes. I did 0.6mm nozzle, 0.2mm layer height (Prusa DETAIL profile), 100% infill.
Hinge
Paint on supports to the build plate for the unsupported inner diameter of the recessed bolt holes and for the hinge bosses. I did 0.6mm nozzle, 0.2mm layer height (Prusa DETAIL profile), 100% infill.
Assembly
- press the hex nuts into the Gasket Base
- using the two spacers, screw the Lid Base to the Gasket Base
- these are the two holes directly opposite one-another, i.e. at “3 and 9” on the clock
- carefully transfer the OEM Dyson gasket to your 3D printed assembly
- take your time, tug on it gently in different areas to get it seated well
- install the Clip and the Hinge parts
- use a small flat head screwdriver to install the hinge into the vacuum dust bin
- I found inserting one hinge boss first, then using the screwdriver to pry the second boss into place worked well