Bandsaw Veneer Roller the Veneer Dominator
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A bandsaw veneer roller for cutter veneers easily. Lots of plastic
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 109
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Public Domain
Ok this is bandsaw jig for a larger bandsaw to create a large roller fence. I saw them online and they are pricy.
The design uses a lot of plastic and i used abs gf for most parts however i dont think its to importnat.
So print the 4 faces which the rollers go in and insert the correct number of bearings. I used 636 bearing as i had a load. Then print the rollers you will need 10. These are designed to take a 6mm rod cut to fit the gap. I needed a reamer or a long 6mm drill bit to get the rods through but i wanted a tight fit.
The rods for the roller need to be about 2-3mm shy of the recess at the top of the bearing holes
The faces are designed to be strengthened with approx a 25cm 6mm rod and epoxy in the two spare triangle holes horizontally top and bottom.
The top left and right are glued together and the bottom left and right.
By keeping these as two halves if a roller is damaged they can be replaced. The two top and bottom sections are joined by 6mm studding in the long vertical holes.
Before you put the rollers in rember to put 4x 8mm x 80mm (ish) bolts sticking out the back to mount the back bracket.
The face has a hole for a magna jig to help beef up the locking of the roller to the table of the bandsaw. I am not sure its required.
Print the back bracket this has some play so you can adjust for square as the face had some warp in printing on my machine.
Print the rod and the sleeves. This is glued into the back bracket. I found it easier to use the sleeve to get a tight fit. I used cynaacrylate and some scissors to get a good fit.
Then print the bandsaw fence mount this is for a felder fb510 fence but you can edit to fit any badsaw fence. Then print the rod insert for fence. This has some holes for 8mm bolts to allow you to lock the rod (i used a threaded knob to tighten this)i have also included two small sleeves to adjust fit. easily fitted with some glue.
This is a solid jig and unlikely to be made by anyone else ever but if you fancy it here is a rough ish set of files.