Apple TV Remote Case with Power Button Fix (2nd & 3rd Gen)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remote case plus a button to replace the one that fell out of my remote.
- Ocena
- 5 / 5
- Polubienia
- 7
- Pobrania
- 52
- Wydruki
- 1
- Wyświetlenia
- 544
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Living Room
- Licencja
- Creative Commons — Attribution
THIS WILL NOT WORK IF YOUR POWER BUTTON IS STILL IN YOUR REMOTE.
Update: After a bit of time the remote loosened up and the remote does not stay in place. I made a tighter V2 version that should help prevent that. I also made the charge port bigger.
The power button fell out of my Apple TV Remote. I originally replaced the power button, however that eventually fell out too and never quite clicked right.
Borrowing this model I added a top section with a button. Styled slots added for the mic as well.
I printed in PLA at 0.2 layer height & 15% Infill, seam on the back. Print in the orientation the files are in. There should be no need for supports as I added a single layer support for the button that will need sliced/broken when the print is complete. Without it, the button printed wonky, even with supports.
Carefully slide the top onto the remote and, with a pair of tweezers or small Flathead, gently lift the button over the front of the remote to set it in place. It should rest in place inside the remote housing.