Chair wall hooks
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Chair hooks for hanging things off the wall using double sided foam tape
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 179
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bedroom
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted a slightly less boring hook for my wall so I made these :) I saw them at Ikea, but those require you to screw it into the wall, which I can't do.
Make sure these are printed sideways with supports in the orientation shown in the picture for maximum strength. If you print it upright, it may snap when loaded around the backrest area, after the fillet ends.
The 3D printed models in the pictures are 50% scale of the original models, I decided I didn't need such large hooks in the end. 50% scale was the perfect width for a piece of foam tape.
10% Gyroid infill with 3 walls seems to be sufficient, the foam tape I used failed before the print did.