Replacement water pump cap for RainPoint "Solar Irrigation System"
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A replacement plastic cap with ~1/4" OD barbs used in the RainPoint "Solar Irrigation System" in case yours broke
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 207
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
I broke the ¼" barb off my RainPoint “solar irrigation system” pump and after attempting to just add a barb back onto it (which also broke), I remade the cap with reinforced barbs.
I was able to get it to seal properly enough when enabling Ironing and the below settings in PrusaSlicer, but if you run into leaks such that it can't pull a vacuum, you may need to do something like coat the top with epoxy to seal it.
Print settings on Prusa Mini S in PrusaSlicer:
Layers and perimeters:
Layer height: 0.1mm
4 perimeters
Seam Position: Random
Infill:
Top fill pattern: Archimedean Chords
Bottom fill pattern: Archimedean Chords
Ironing enabled
Support material:
Generate support material
Style: Organic
Support on build plate only
Speed:
Perimeters: 60mm/s
Small perimeters: 15mm/s
External perimeters: 50%
Infill: 80mm/s
Solid infill: 20mm/s
Top solid infill: 15mm/s
Support material: 60mm/s
Support material interface: 100%
Bridges: 35mm/s
Gap fill: 20mm/s
Ironing: 15mm/s