Tandem Magazine for Nerf Blaster (Require a modified pusher)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A double stack-ish magazine for nerf blasters, will require a modified pusher
- Ocena
- 5 / 5
- Polubienia
- 49
- Pobrania
- 103
- Wydruki
- 2
- Wyświetlenia
- 1883
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial
Tandem Magazine. A double stack-ish short dart magazine for full-length magwell.
This Magazine REQUIRES a Modified Pusher to Function Properly!
Currently Available:
Demo:
Features
Tandem Magazine is basically full-length magazine split in half, doubling its capacity. Just load each column up like normal mags.
The Basic Base holds 6 in the front column and 5 in the rear column, the 23 Darts Extension holds 12 + 11 darts, and the 31 Darts Extension holds 16 + 15 darts.
Some darts are longer (like 40mm) than standard darts (38mm), which might jam the magazine up. If you feel any abnormal resistance when loading the mag, swap out the too long darts.
Update:
02/19/2025:
Followers: Make the cutout for the reels bigger and increase the size of the pulleys.
Magazine Main Body: Adjust the groove in the rear column so that it limits the travel of the rear follower. Add a cutout to the front of the magazine hopefully make it feed more reliably.
Extension: Add some chamfer to make the main body easier to insert.
This update will decrease the magazine capacity by 2, as the followers are slightly longer.
Printing:
All the parts can be printed without support. 2 wall loops should be enough for all the parts. You can add a modifier to the lips of the magazine, giving it more walls to make it stronger so it won't break that easily like in the demo. But I will recommend just be careful with it.
You will need a printer that can print 170mm height in order to print the 33 darts version.
Hardwares
2 * ID Badge Reels (roughly 32 mm in diameter)
4 * M3 x 5 mm screws
1 * M3 x 5 mm steel screw (has to be made of magnetically attractive material, recommend flat head)
About 80 mm of 1.75 mm filament
Assembly
Check the Assembly Guide in Other files
For Other Creators
If you want to create a modification for your flywheel blaster, the requirements for the pusher are:
- At least 44 mm of stroke (recommend 44 ~ 47 mm)
- A magnet embedded in the head of pusher (I used a 4 * 4 mm magnet, polarity doesn't matter)