reunu Charger Case v2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Case for battery communication components needed to construct an alternative charger for the unu Scooter Pro.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 1
- Wyświetlenia
- 59
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Case for battery communication components needed to construct an alternative charger for the unu Scooter Pro.
Should print without supports. Base prints upside down, Cover attaches with press fit and becomes the bottom. Components are mounted using M3x4 or M3x6 screws. Anything longer than that will likely damage the case.
Upper battery receiver and pin connector housings forthcoming.
Use this XT60 panel mount: https://www.thingiverse.com/thing:3530615 Solder wires to the XT60 connector, insert it into the panel mount, and secure the plug with one or two M2 screws (approx. 4mm, from top and bottom). Then insert panel mount into case and fix with M3 screws.
BOM:
- 2x Elechouse PN532 https://www.elechouse.com/elechouse/images/product/PN532_module_V3/PN532_%20Manual_V3.pdf
- 1x LoLin NodeMcu v3, like https://www.aliexpress.com/item/1005007384822256.html
- 1x 213 terminal: https://www.aliexpress.com/item/1005007008409625.html
- 1x DC/DC 58V/5V3A with Micro-USB out: https://www.aliexpress.com/item/1005008207469533.html
- 1x XT60 female plug housing
- suitable wires (~14AWG)
Category: Other