Cord Clip Plug Keeper - Flex Version - Two Sizes
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple clips to attach the loose plug end to the power cord.
- Ocena
- 0 / 5
- Polubienia
- 20
- Pobrania
- 87
- Wydruki
- 0
- Wyświetlenia
- 442
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Public Domain
These simple clips are designed for standard power cords with a cord diameter of approximately 6 - 9.5mm (and possibly larger). They are designed to be used in a situation where the loose length of a power cord is wrapped around some sort of holder, but the plug end is left dangling free - these clips temporarily fasten the plug end to the rest of the cord.
Previously, I designed different versions of these for printing in PLA (see re-mix). However, the PLA version was limited in the cord diameters which could be accommodated by a single size clip. These flex versions are more flexible (!), and can adapt to a wider range of cord diameters. However, I still found it necessary to make two different sizes in order to cover a wider range of cord diameters.
The two sizes are for base diameters of 6.0mm and 8.0mm. Note that each clip has a 3-finger side and a 2-finger side. The 3-finger side is the “permanent” clip (it always stays on the cord), while the 2-finger side holds the removable plug end of the cord.
Print Instructions
Print in FLEX using the 3mf or gcode files provided. In general :
- 15% rectilinear infill
- perimeters =4
- keep fan always on
Print with the 2-finger end down. Note that I found it necessary to print with the cooling fan always on; otherwise, I ended up with a melted blob.
CAD
The OnShape 3D CAD files for this are here :