Water Dispenser lever for KitchenAid and other fridges
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Share Alike
Water Dispenser lever for KitchenAid and other fridges
This lever allows for dispensing of crisp cold water using one hand.
Tested on KitchenAid model KBFS22EWMS but the same model is branded under Whirlpool and Frigidaire. Bracket part is same as Whirlpool fridges so this will likely work on other brands as well.
Print with model on it's side with supports. PETG or PLA.
Note: If the lever is not pressing on your fridge button, tape or glue a small piece of thin cardboard to the lever. This will allow you to fine-tune the pressure applied to the button.
Remove the trim piece above the water button and install the printed part in place of it. (see photos)