Cyclone Separator to Hose Adaptor
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This adaptor is required for how I use the cyclone separator. The separator is made to attach standard shop vac hoses…
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 57
- Wydruki
- 0
- Wyświetlenia
- 1187
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
This adaptor is required for how I use the cyclone separator. The separator is made to attach standard shop vac hoses to via friction fit. I am attaching the separator to a 2.5-inch flexible hose for a dust collection system. The inside diameter of the flexible hose is larger than that of a standard shop vac hose so it does not fit. This adaptor allows the flexible hose to fit and as well channels the airflow into the separator. It also blocks dust and particles from wedging themselves between the hose and separator at the connection point.
Print Settings
Printer Brand:
Ultimaker
Printer:
Ultimaker 3 Extended
No
Supports:
No
0.2 mm
Infill:
40%
Notes:
I printed this in ABS with the "cyclone side" down on the build plate with the center of the cylinder vertical. The angle of the overhangs is small and it printed without issue. It took about five and half hours at 0.2 mm, but my print settings are conservative and the layer height was smaller than it really needs to be.
Category: Parts