Prusa XL Filament Sensor Bypass For PC4-M6 & M6 Inserts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Yet another filament sensor bypass modification.
- Ocena
- 4,5 / 5
- Polubienia
- 13
- Pobrania
- 55
- Wydruki
- 2
- Wyświetlenia
- 399
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- GNU General Public License v3.0
🟩 🟦 🟦 🟪 🟥 🟧 🟨
Prefix: I suggest using this one instead, its a little harder to print but cheaper to build and much more reliable!
I wanted a filament bypass sensor with proper connectors in both ends and that uses an insert, so reverse engineered the STL provided by Prusa with Quicksurface Pro to get the correct dimensions for fitment and made the necessary modifications.
Initially I found the filament was hard to thread through with the filament catching in the middle, however I discovered this seemed to be because I did not insert the PTFE in properly so it mates in the middle.
The CAD file is also included so others can easily make their own variations.
You will need the following to complete a build of two fully loaded models:
6x Ruthex M6 inserts - the height of the insert (12.7mm) is important in this model so non-Ruthex inserts may fare less well.
12x PC4-M6 connector. I got the ones from “Bambu Lab Maker Supply” but others will probably be fine
To build the model install the inserts in the holes, then screw the PC4-M6 connectors in either end of the insert. Note that the depth of the area where you install the inserts is the same height as the insert, so take care to stop the area under the model from burning.
If you like my designs or find them useful it would be great if you can support me by joining my club on Printables for at least a month, which gives you access to various extra models for the duration of membership. Another alternative is to buy me a coffee over at ko-fi via this link. Thank you!
🟩 🟦 🟦 🟪 🟥 🟧 🟨