Sovol SV08 BTT Eddy mount for tap
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
BTT Eddy mount for the SV08 stock toolhead, coil at 2.98mm
- Ocena
- 4,667 / 5
- Polubienia
- 40
- Pobrania
- 375
- Wydruki
- 2
- Wyświetlenia
- 3714
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a mount for the BTT Eddy (Duo) for the Sovol SV08 stock toolhead that positions the eddy coil about 2.9mm above the tip of the (stock) nozzle. This distance (or something close to it) seems to be required to enable “tap” z-offset adjustment with my experimental Eddy functionality in Klipper.
You'll need a 20mm M3 screw. You may also want some small self-tapping screws to secure the Eddy to the mount, but it's a fairly tight friction fit. The screw posts should go through the mounting holes on the Eddy. Once it's in, it should be pretty difficult to move: I've been running mine without any additional screws for a while.
Add some supports to the little locator post, and clean up that post post-print to make sure it fits into the hole in the toolhead plate.
You will need to cut off a small piece of the stock toolhead shroud to make this fit, as seen in the photo.
The probe offsets for this mount when used with the stock Sovol SV08 toolhead are roughly:
x_offset: -18.0y_offset: 6.0