1 / 4
Neptune 4 Max auxiliary fan wire protecting plate — zdjęcie 1
1 / 4

Neptune 4 Max auxiliary fan wire protecting plate

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A plate protecting the auxiliary fan of the Elegoo Neptune 4 Max printer from being ground by the cable chain.

Ocena
0 / 5
Polubienia
12
Pobrania
110
Wydruki
1
Wyświetlenia
620
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

I noticed that when cable chain is added to the print head, it sags a bit and rubs the wire that powers the auxiliary fan. Even though I taped it down to have the lowest possible profile, the chain was still hitting it, so I decided to design and print a part that will protect it. It is attached with one of the screws that are used to attach the fan itself to the gantry. It has a bit of a angle to it, so that it fits with a bit of a tension, which helps it to be as tight as possible against the top of the fan. That's why I recommend to print it in PETG. PLA might snap under this tension.

 

You need to remove some kind of a tape that is used to attach the braided sleeve to the wire. And then pull the sleeve up and put the wires into the channel of the plate and then tighten the screw. This is so that the plate had the lowest possible profile above the fan. The chain will still hit it, but it will slide right over it. At least it won't grind the wires.

Tagi