DHT22 wall mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I needed a holder that took into account the circuit board and the jumper wire connector and used double sided tape to…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 104
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
I needed a holder that took into account the circuit board and the jumper wire connector and used double sided tape to hold it in place. You could feasible use foam or some backer to hold it in as well. I used a .8mm nozzle with a .2 layer height and 1.6 shell thickness with a very low fan speed.
I have also added the python script I use on my Raspberry Pi to trigger a switch via IFTTT. The first version of the script goes off of a set humidity level while the second wait for a change of more than 2% within 5 seconds and trigger the light based on that.
Print Settings
Printer Brand:
Prusa
Printer:
Prusa Clone
Doesn't Matter
Resolution:
.2
15
Filament: Inksmith ABS-X White
Notes:
Printed with a .8 nozzle at a speed 50 with no post processing.
Category: Electronics