TTArtisan 23mm F/1.4 Rugged Box
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Carrying case for the 35mm TTArtisan F/1.4 lens.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 81
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Everything is printable without supports. Print the Seal and all the parts labeled “inserts” out of TPU, print the inserts with 0 top layers, 1 perimeter and 10% gyroid infill. Cut the two long inserts to length after printing, they are a bit too long by design.
You will need 3x M3x30mm screws for the hinge and latches.
If you are experiencing too tight of a fit when closing the box, try scaling down the seal in the Z direction to maybe 1.2mm or just use the box without the seal installed.
The same applies to the fit of the lens, if it is too tight or loose for you try scaling down or up the inserts in Z height.
Thanks to @Whity for the parametric design of the rugged box I used and @Yanev for laying the groundwork before him.
I recommend printing the box, lid and latch with “Fuzzy Skin” applied only to contours, I use 0.3mm point distance and 0.1mm thickness.