RC4WD Mojave II - Body Parts / Update 29.08.2026 - Shock-Tower Cover and Battery Box Combo
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I've gathered all my Mojave II files here. Enjoy.
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 81
- Wydruki
- 0
- Wyświetlenia
- 575
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
Hard Tailgate Logo
I mounted the logo on two crawlers, variant 1 works better for me and looks cleaner. In variant 2, the glue dissolved the paint a bit (picture 1).
Variant 1: Place the template on the tailgate and mark the letters. Remove the stencil and glue the letters onto the marking.
Variant 2: Clamp the template to the tailgate, spread glue on the back of the letters and insert the letters into the template. Only remove the template when the adhesive is really solid.
RC4WD Mojave II Four Door on SCX10 / Shock-Tower Cover and Battery Box Combo
I was looking for a solution to hide the shock towers and change the battery without removing the body.
Need 2x5x20mm neodymium magnets.
One magnet in the lid and box (magnet_holder) is enough, otherwise it will be difficult to open.
Magnetholder must glued to the box (2x).
Magnets must be glued in with epoxy.
Screws for the lid hinge are M2x16mm (do not tighten too much).
Printed in PLA with 15% infill.
If the printer has good cooling, no supports are necessary.
Front lid doesn't really make sense and can be glued to the box.
Handle must be glued to the lid (print it 2x).
Box is attached to the truckbed with M3 screws or double-sided tape.