1 / 2
DNA model ornament
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Sculptures
- Licencja
- Creative Commons — Attribution — Noncommercial
Print Each Part Separately 🖨
IMPORTANT ⚠
For the strand with no base, use a 5mm brim so it doesn't fall.
SUPPORTS 🛠
- CAN be printed without supports, but you need to use a 0.12 mm layer height if you don't want to sacrifice quality.
- Be prepared for a little sanding or torching.
ASSEMBLY 🧩
- Take the strand with no base and heat it up with a heat gun until it is slightly soft.
- Take the low part and screw it into the one with a base.
- ⚠ As these are molecular models, they must remain in the orientation they were printed. Otherwise, they won't fit.
- Once the low part of the no-base strand touches the base, align it from above and hold it in place until it cools down. ❄