Wall Holster for Bosch eBike Battery Charger 36-4
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A wall mounted holster for a Bosch 36-4 eBike charger so I dont keep kicking it around on the floor. Holds the charger…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 289
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial
A wall mounted holster for a Bosch 36-4 eBike charger so I dont keep kicking it around on the floor. Holds the charger pretty securely, it's not going to fall out.
Jan-2020 : I have uploaded a new version of this; with a clip to hold the charger plug when not in use. I also slightly updated the design to tighten the fit on the 'wings'. I have uploaded models for both left and right clips, plus a 'no clip' version.
- My specific charger has the part number 0 275 007 907, but I suspect this fits any of the 36v 4A chargers in the powerline range.
- If you have the 6A charger please check out: https://www.thingiverse.com/thing:5199326 This is a remix of this model for the fast charger.
- For reference, on my charger the base is 75mm wide and 170mm long. The top is 85mm wide and 50mm tall at it's maximum (measured from the base, not the feet).
There are two 5mm mount holes (+ recess and adjustment) for mounting but my target wall is 35+yr old reinforced concrete and I didn't want to borrow my neighbours SDS drill (again), so I also put a big base on it and have stuck to the wall with carpet tape..(strong stuff). I deliberately left a big air channel behind this to assist cooling.
- Thanks to @zlogg, who originally pointed out that thisdoes not work with the 36/6 fast charger models, it is designed for the 36/4 normal (4 amp) chargers.
PS: sorry for the awful lighting in the photos, my phone camera did not cope well with very black objects on a white wall.
Print Settings
Printer:
K280
Rafts:
No
No
Resolution:
0.2
20%
Filament: Real Filament PLA Black
Notes:
Quite a chunky print, I do not want it to sag with age so I set infill to 20%.
Category: Organization
