Baroque Door Knob
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a little baroque door knob I designed and sculpted in Blender 2.8 as a replacement for the original that…
- Ocena
- 5 / 5
- Polubienia
- 24
- Pobrania
- 120
- Wydruki
- 2
- Wyświetlenia
- 365
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
This is a little baroque door knob I designed and sculpted in Blender 2.8 as a replacement for the original that broke.
It was printed vertically at a 0.12 mm layer height with standard PLA. The knob has a diameter of roughtly 2.5 cm (or one inch) but you can scale it in your slicer.
The part is designed to be used with a threaded insert that you will have to insert in the part with a soldering iron : just place your threaded insert above the hole in the part an touch the insert with your soldering iron. The insert should set in place strongly in the plastic part with that little bit of heat. The hole for the insert on the 3D model is exactly 5.85 mm diameter.
It has served its purpose on a bathroom cabinet for several months and I hope you will like it!
Print Settings
Printer:
Alfawise u30
Rafts:
Doesn't Matter
Doesn't Matter
Resolution:
.12 mm layer height
20% cubic infill
Filament: ERYONE PLA Grey
Category: Replacement Parts