1 / 6
Creality K1C/K1 Chamber Heater — zdjęcie 1
1 / 6

Creality K1C/K1 Chamber Heater

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Printer chamber heater. Assembled from a standard auxiliary fan and a PTC heater.

Ocena
5 / 5
Polubienia
131
Pobrania
200
Wydruki
1
Wyświetlenia
6564
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

BOM:

  • 1 x 12032 Blower Fan. I unscrewed the side blower and turned it over.
  • 1 x 220v 45x55x15 300w PTC Heater Core.  Buy there and disassemble it https://www.aliexpress.us/item/2251832781637089.html
  • 7 x M3 Heat Inserts
  • 4 x M3 20mm or longer BHS
  • 2 x M3 10mm BHS (For the PTC heater)
  • 1 x KSD9700 120С 5А 250В normal closed thermal relay
  • Brown High Temperature Resistant Kapton Tape Polyimide For Electric Task/grills/powder coating - for relay/heater isolation

I printed a part for myself using Polymaker PET-CF and then annealed it. It works great, no problems at all. I also printed one for my friend using PA-CF. That one's working perfectly fine too. For testing purposes print this part from ABS-PC. In normal mode it will not overheat and will not melt. Then I turned off the blower and before the relay triggered the case was slightly deformed. So you can either install a lower temperature relay  (KSD9700 100C) or print it from a more heat-resistant plastic as i said above (PET-CF, PA-CF)

The firmware modification and connection diagram (in Russian) are described here . You can figure it out using the pictures and code.