Park Tool Truing Stand TS-2.2/2.3 Accessory - Stand Support Legs
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Support Legs for Park Tool Truing Stands. May work with other Park TS-2 truing stand models (use test print to check).
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 52
- Wydruki
- 0
- Wyświetlenia
- 298
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
This is a remix of the legs made by Kamil Dolezel. Keeps all the useful slots/recesses for core removal tools, spoke wrenches, etc… while adding a few more spaces for a picking tool or pens and adds a more supportive base. This version is easily assembled, as described below.
Printed in PETG with normal supports.
I used a 0.4mm nozzle, 0.2mm layer height, 25% infill, and 3 wall loops.
Requires two ¼" hex nuts and two ¼" bolts for assembly. I suggest bolts that are an inch long, or inch and a half at most.
Assembly Directions
To clear the supports, I used a picking tool (see last image) and plunged the bolt from the top hole to push out the underside support. Use some CA glue (super glue) to embed the hex nut into the recessed hex portion of the print. Slide the legs into the openings within the stand's frame. Insert the bolts into the hole on the underside of the print and tighten to your liking.