Home alarm wiring tester - Tester pro drátový alarm - s WIFI
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Nástroj pro testování drátových alarmů, "hledání duchů" na kabeláži například mezi čidlem a ústřednou. S WIFI ovládáním
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 39
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
(under work) - I appreciate like or comment as a motivation
Primary developed / primárně navrženo pro testování Jablotron Oasis. But may work for other alarm systems that use balanced loops.
A tool that helps you test wired alarm systems, in case you are suspecting wiring as a problem (or you want distinquish whether problem is in sensor or in the house wiring).
This box is fake sensor, with “balanced” 1k + 1k resistances. It is equipped with WIFI server, sou you can remote control it by smartphone, when you are close to alarm central unit and you checking that.
Alarm (sensor wiring) test procedure
- Replace suspected sensor by this box, connect +12V, GND, signal+ and signal-
- Resistors are included, so shall be removed from existing wiring
- Go to alarm central unit
- Seek for WIFI AP and connect
- Use web browser for 192.168.1.1 and you open control webpage
- Remotely via web browser you can switch on/off the alarm event
- And then you check wiring whether signals are fine.
There is 3D printed enclosure, that incorporates PCB, ESP32, and terminals to alarm wiring.
The switch for alarm loop is galvanically insulated, so you can also use alternative power source like USB powerbank and feed power thru USB. In this case you just connect signal+ and signal- terminals to wiring.
There is jumper, that allows you turn-off the serial 1k resistance in detection loop.
Current firmware version can do only this (described above). I have implemented also +12V measurement (you will see voltage on www page) and even I want add some detection, for example for voltage lag, that may inform you that wiring (+12V or GND) is somewhere little bit interrupted. There are 2 LEDs and 2 buttons that can have specific function also.
