OM-SYSTEMS LS-P5 Tripod mount Carrier

I bought the OM-SYSTEMS LS-P5 audio recorder so that I could record music played at my local music group sessions. I bought a kit which included a soft case although I then made the hard protective case published by 3D-Ghanji on Thingiverse, (Thing 6207328) which is a lot better when stored in my camera bag for example.
 

I always intended to mount the recorder on a small tripod but where in use, the LED which indicates that it is recording was way too conspicuous. The obvious solution is to use sticky tape to cover the LED but I didn't want to do this as I wanted to keep everything clean and avoid the possibility of dirt building up on what would be a sticky area once the tape had been removed.
 

My solution was to design a carrier which would screw onto the tripod and hold the recorder whilst in its soft case. (The3 microphones are not enclosed by the case which means it can stay in position). As I control the recorder via Bluetooth, once switched on, the recorder can go back into its case.

Print upright and once complete, push a 1/4" UNC nut into the internal space. This can be a bit tricky as the space for the nut is purposefully tight - I used a pair of long-nosed pliers to get the nut home - it should not protrude into the main space.
One of the photographs show the recorder in the carrier without its soft case and it CAN be used that way - the size of the carrier though is large enough. to hold the recorder whilst in its case.