Shorter Wingtip for Volantex ASW28
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Basically, a wingtip, and a shorter one compared to the kit.
- Ocena
- 5 / 5
- Polubienia
- 2
- Pobrania
- 35
- Wydruki
- 0
- Wyświetlenia
- 144
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Share Alike
20250531UPDATE:
Sand the upper part of the rear bump a little if fitting difficulty is encountered.
INTRODUCTION
Basically, a wingtip, and a shorter one compared to the kit.
Out of my unwillingness of finding places for the thick ones when travelling,these wingtips came into being.They were designed to be glued to the wings and simply slide into the protection bag together,not much room needed. They are more for the slope than thermal,but anyway,better than flying with bare wingtips.
As for the settings,
PLA+ white from esun
,0.8mm thick for wall top and bottom
suggested layer height varies from 0.16 to 0.21
2% infill
tiny amount of support and brim needed
mirror to get a pair
glue with silicone sealant(704)
they should be placed with the lower part of the connector touching the bed and form an angle of around 55 for the best result
Enjoy
Lynn