VH-109 Radio Mount for FIRST Robotics Competition (FRC)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A mount to hold the new FRC VH-109 radios without covering too much surface area
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 200
- Wydruki
- 0
- Wyświetlenia
- 671
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
This is an over the top style mount for the VH-109 FRC radio. It was designed to not cover or interfere with any functionality of the radio. Lights are visible and ports are clear. Minimal amounts of the radio are covered to allow air flow to the radio.
At this point, no mounting holes are included and need to be added. Make sure to use 100% infill to prevent strength loss when drilling.
For ease of print, print upside down so only the mounting tabs need support.
For strength, it is possible to print it on it's side but it will require more and harder to remove supports. Use the No Mesh version to reduce the supports needed
I printed @ 0.2 mm w/ a 4mm nozzle on my Bambu A1 mini
- 100% infill
- Manual supports for the mounting tabs. (Do not auto support or it will try to support the exterior hexagons too)
- No brim