1 / 5
Replacement nose pad for Bollé Rogue tactical goggles — zdjęcie 1
1 / 5

Replacement nose pad for Bollé Rogue tactical goggles

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Replacement nose pad for discontinued model of tactical goggles, cannot be bought anymore.

Ocena
0 / 5
Polubienia
3
Pobrania
21
Wydruki
0
Wyświetlenia
221
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Sports
Licencja
Creative Commons — Attribution

Replacement nose pad for discontinued model of tactical goggles, cannot be bought anymore (even the manufacturer doesn't produce replacement parts)

  • Printed from TPU on low speed, with ultra high quality settings
  • If you need both left and right, just mirror the model in the slicer along the X axis.
  • When printing both, I highly recommend to set Print sequence to “By object” to avoid stringing between the parts.
  • Print standing on the bottom part with the holes, no supports needed, only outer brim recommended.
  • Dry your TPU before print.

Print with 0.4 mm Nozzle:

  • 0.08 mm Layer height
  • Only 1-2 walls 
  • 15% Gyroid infill
  • Snug fit - doesn't need glue

Experimental (not recommended as default) Print with 0.2 mm Nozzle:

  • 0.06 mm Layer height
  • Speed only 10 (Initial layer) - 20 mm/s (Other layers) + slow down for overhangs to half
  • travel speed 80 mm/s
  • Outer Brim with 0.2mm gap
  • Print sequence By object (when printing 2 pieces)
  • 3-4 Wall loops
  • 5 Top and Bottom shell layers
  • 0% infill
  • 5% up Flow ratio
  • Nozzle temperature 205 C (210 C for first layer)
  • Bed temperature 55 C (60 C for first layer)
  • Fan speed 30 - 60 %
  • Retraction speed 20 mm/s
  • Retraction length 0.8 mm
  • Z-hop 0 mm
  • Would probably need a drop of glue to stay safely attached

⚠ This setting is tested with SUNLU TPU 95A, if you use any other, some settings may need adjustment.

Tagi