Sovol SV08 Lack table top adaptor
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a set of spacers to allow you to mount a Lack table top on top of the SV08. You will lose some height...
- Ocena
- 5 / 5
- Polubienia
- 20
- Pobrania
- 50
- Wydruki
- 2
- Wyświetlenia
- 1170
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
While assembling my SV08, I noticed that it had almost exactly the same dimensions as an IKEA Lack table. This set of prints is for people for whom almost isn't good enough. You will need to print 2 of the corner.stl, which I believe are the front left and rear right corner pieces, and 2 of the corner2.stl, which are the front right and rear left corner pieces, as a minimum. The grommet.stl is a grommet to put in an 8mm(3/8") hole drilled through the top of the table for the reverse-bowden tube. spool-adaptor.stl is an adaptor which allows you to turn the stock spool arm into a free-standing support which you can put on the table. spacers-and-grommet.stl is what it says on the tin, everything you need except the spool adaptor, in one file. You should not require supports for any of these parts, and the stock M4 bolts for mounting the spool arm will work with this part. I recommend a high infill (I used 75%) for the spool adaptor.
I believe the extra mass of the table and all of the stuff on it may be lowering my maximum usable accelerations, but the convenience is worth it so far. I am considering printing the adapters in some sort of TPU to see if that helps, or (as suggested in the comments) adding some sort of screw holes to improve the rigidity of the printer.
