Magnetic Under-Desk Mount for LTT Precision Screwdriver Bit Set
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Allows magnetic mounting of the LTT Precision Screwdriver bit set to the underside of a surface without modification.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 132
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
This does not require modification to the LTT Precision Screwdriver Bit Set. It uses the existing metal pins located in the corners of the bottom of the bit set that are usually used for snapping the lid to the back.
In addition to the print, you will need:
- 12 6x3mm cylindrical magnets
- 6mm diameter, 3mm thick
- Mine have actual dimensions of 6x2.64mm
- I did initially try using just one or two magnets per corner, but found the holding strength to be too weak.
- Some 2.5cm wide double-sided adhesive
- I used 3M VHB
- Command Strips might work if you're after a less permanent solution.
- Your preferred glue
- Might be optional, depending on printer tolerances. I didn't need it.
After printing, press three magnets into each corner, using glue if needed. After inserting the magnets, apply your 2.5cm wide adhesive to the flat side of the print (the side you should've printed down), then mount as desired.
This will not work as a wall mount in its current form, due to the laws of physics. With the addition of a small shelf at the bottom of the print to hold the majority of the weight, it probably would work as one. If there's interest, I could add this, but I've also included the Fusion360 file.