ViFly Mount and TPU Button for SpeedyBee Mario5 Frame
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This mounts your ViFly beacon inside the frame. There is a TPU button for turning off the beacon.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 23
- Wydruki
- 1
- Wyświetlenia
- 226
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
This is a housing to hold the ViFly Beacon on the Mario5 Frame. It uses a TPU Button to press the button on the ViFly Beacon from the bottom of the frame.
I have only tested this with an HD Zero Camera. Other systems/cameras may not fit.
I printed the housing from PETG CF, but I think any rigid filament would work (TPU might be too flexible for the housing). The housing should be protected from any impact, as it is well inside the protection of the frame itself.
(2) M2 screws are required to mount the housing, and you may want to use some ShoeGoo or other flexible adhesive to help hold the ViFly beacon in the housing, if the friction fit is not sufficient.
Use the included drill jig to drill a 6.35mm hole in the frame (the jig locates the drill bit in the correct location