Easy to make enclosure for any 3d printer, all sizes possible.

I wanted a enclosure for my Anycubic Kobra Plus and since this model is too large for the Ikea Lack I created one from scratch. Dependent on the length of the poles you use this can be used for all sizes printer. 

I used 44x44 mm poles (for the old-fashioned imperial users, this is about 1 ¾ inch). With a router on my Dremel I created the slots in the wooden poles to fit plexiglass in the poles.

Printed with PLA

• infill 20%
• tree supports
• layer height 0.2 mm

Other materials used:

• 44 x 44 mm wooden beams (about 1 ¾" x 1 ¾" )
• For connecting the corner pieces to the poles I used 24 (3 per corner) 6x60 mm woodscrews https://www.amazon.nl/dp/B007MADO36?ref=ppx_yo2ov_dt_b_fed_asin_title
• For connecting the hinges to the poles I used 8 (2 per hinge) 3.0x30 mm woodscrews https://www.amazon.nl/dp/B01LM20MLQ?ref=ppx_yo2ov_dt_b_fed_asin_title
• The magnets used are standard 6mm x 2 mm magnets (like the ones you use with Gridfinity) https://www.amazon.nl/dp/B09H34QS6C?ref=ppx_yo2ov_dt_b_fed_asin_title
• On the pole I used self-adhesive metal plates https://www.amazon.nl/dp/B0DF38539M?ref=ppx_yo2ov_dt_b_fed_asin_title
• M3*10 and M3*40 screws for the hinges https://www.amazon.nl/dp/B0B3MGZ7T2?ref=ppx_yo2ov_dt_b_fed_asin_title
• 3 mm (3/16") plexiglass (for the sides and the top, this was sturdy enough, as tested even my cats (6 kg each) can sit on it. 
• 4 mm (5/16") plexiglass for the doors
  Warning: use casted plexiglass for drilling holes (extruded plexiglass can/will give stress cracks), use a HSS drills or even better a cadmium drill
• PG7 cable gland for filament throughput (8mm drill) https://www.amazon.nl/gp/product/B0DT14CBFP/ref=ox_sc_act_title_1?smid=A1E051L86G0IZ9
• small rubber hammer to hammer plexiglass in the slots https://www.amazon.nl/dp/B0B7MVH989?ref=ppx_yo2ov_dt_b_fed_asin_title

Extra's:

• A thermometer just to monitor the temperature inside https://www.amazon.nl/dp/B000EOR47Y?ref=ppx_yo2ov_dt_b_fed_asin_title
• Led string (10 m)