Raspberry Pi 4 + Geekworm P388 rack-mount bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Rack-mount bracket for Geekworm P388 Raspberry Pi 4 case (and others)
- Ocena
- 4 / 5
- Polubienia
- 12
- Pobrania
- 104
- Wydruki
- 1
- Wyświetlenia
- 805
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Public Domain
Rack-mount bracket for the Geekworm P388 Raspberry Pi 4 case.
Probably also works with other cases that have a similar footprint, like the P173 (Pi 4) and P252 (Pi 3), but I haven't tested. Note that these cases have their two right-side screws offset from the actual Pi mounting holes. Many other cases, including the P573 (Pi 5), use the Pi hole pattern directly, so they won't be fully compatible with this bracket.
Required hardware:
- 4x M2.5 x 15mm screws – the ones that came with my case weren't long enough
- 4x M2.5 washers – optional but recommended
All I/O is accessible, including the SD card and GPIO slots.
The left side of the bracket has a slotted “shelf” to secure/relieve the power cable. This works best with cables that have a 90° plug. There is also a small loop on the right side in case you want to secure something there, or in case it isn't supported well enough using just the rack screws.
I only created a right-mounted bracket. A proper left-mounted one probably needs a slightly different design to prevent the cables from fouling against the rack. But this one should also work very well upside down if you need it on the left.
Please note: I originally designed this with MJF or SLS printing in mind. It prints OK with FDM – obviously requiring supports – but could definitely be optimized better for it. The side wall in particular is pretty weird (I was trying to minimize material without compromising rigidity). A hexagon or diamond pattern would be better, especially if access to the GPIO slot wasn't needed.
The example in the photos was printed using JLCPCB's MJF nylon service. There is just a tiny bit of sag with this material. I think PLA works a little better at first due to its stiffness but it may sag worse over time. I only tried it very briefly.
Links:
- P388 on Geekworm's shop
- P388 on Geekworm Wiki
- P173 (probably compatible) on Geekworm Wiki
- P252 (probably compatible) on Geekworm Wiki
Change history:
- v36 – 2025-01-19 – Initial release.