NB Miata E.G.R. delete plates
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Something easy for my trasnition to Solidworks
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 124
- Wydruki
- 0
- Wyświetlenia
- 509
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
I am installing a kraken low mount and it does not have an E.G.R. bung. My E.G.R. was long deleted ages ago however that plate looked kinda nasty so i measured the stock E.G.R. pipe and valve and recreated them in CAD. They fit very well. I have them installed however they have not been tested as i am still sorting out the oil feed for the turbo. I will update if they survive the temp and boost. I will try without the gasket and see if anything bad happens. If you blank the valve off with a gasket, the pipe blank plate will not need one. You technically only need the plate for the valve, you can leave the pipe portion exposed to air as the pipe portion leads to the valve portion.
Should fit all 1.8s and the B6-ZE found on 1.6 NBs
Printed with 6 walls all around, 100% infill, and using ASA.
01/20/2025