1 / 1
Alternate blind joint jig for Ender 3 NG extrusion drill guides
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Drill guides (jigs) for modifying aluminium extrusions for the Ender 3 NG project; uses F695 bearings for alignment
- Ocena
- 5 / 5
- Polubienia
- 42
- Pobrania
- 189
- Wydruki
- 5
- Wyświetlenia
- 864
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 5) (Komentarze: 11)Remiksy (0)Kolekcje (69)Powiązane
I struggled with alignment issues when putting together my first Ender 3 NG, having used RH3D's drill guides with a drill press and not managed to get the hole alignment quite perfect. Having seen Elliot's design I thought that might make life easier in a couple of ways; I wanted:
- something that would help me to produce consistent, repeatable results, as I wanted to make at least another 2 Ender 3 NG builds
- something that I could hold in place with set screws of some sort
- a jig that I could use with a battery drill, or anywhere where I didn't have access to a drillpress
The BOM is the same as for Elliot's original:
- 2 * M3 30mm screws at minimum
- 8 * F695 flanged bearing
- 1 * 5mm drill bit that can clear 65mm (40mm extrusion +25mm Jig)