RamjetX - Horn Logo - Ken Block Skull
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Hi Internet Sim Racers, By request, here is a Horn 'puck' with the Ken Block Skull Logo on it... I kinda like it…
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 72
- Wydruki
- 1
- Wyświetlenia
- 432
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Hi Internet Sim Racers,
By request, here is a Horn 'puck' with the Ken Block Skull Logo on it... I kinda like it too....
I'm making one in clear to back light it with Simhub for RPM... make the wheel look angrier the harder I drive ;)
Printing tips:
Thin outter walls to maximise the flat fill. Gives the best detail on the skull. 2 lines for walls at most i.e. walls = 0.8mm, and I print pretty slow anyway...
If using Cura, also enable ironing for the best finish ... it looks amazing!
Any request for logos, leave a comment... I'll get round to it for you some time in the week.
Print Settings
Printer Brand:
Wanhao
Printer:
Wanhao Duplicator i3 V2
No
Resolution:
0.2mm layer height
25% ish... just because it gives a good top finish
Category: Hobby