Ankermake M5C Spool Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Lower Spool holder
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 57
- Wydruki
- 1
- Wyświetlenia
- 308
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
I needed a lower spool holder for my M5C. I really liked the original filament guide by Ankermake with the PTFE Tube but could not find anything similar.
I remixed this one cause I really liked the spool holder. But I didn't like the filament guide and after a few tries I made the top part so you can slide on the original filament guide that comes with the M5C.
You can print it, screw it on, slide on the printable spool holder and then slide on the Ankermake filament guide.
I wasn't sure about how well the original part held onto the printed holder. It was only moving a slight bit but seemed stable. I added a bit of hotglue to be safe. Hotglue can easily be scraped off the surface off the M5C guide in case you want to use it again somewhere else.
The backpiece is not necessary and purely for aesthetic reasons.