Copy Stand Base for 3030 Extrusion
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a base to hold a length of 3030 extrusion upright, so you can use TadTadd's mount head without a Valoi stand.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 37
- Wydruki
- 0
- Wyświetlenia
- 232
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial
I needed a copy stand, and TadTadd's camera mounting head looked excellent. Problem is, I didn't have any of the other Valoi components to start with, and I needed something to hold a section of 3030 extrusion upright. I used TadTadd's outline and general aesthetic to make a mounting base.
Printed in PETG, any nozzle, any layer height, 100% infill. You may get away with less material, but I'm trusting this with a heavy, expensive camera. The extrusion should be a press fit in the printed part (mine took a few hits from a mallet), and the base can be bolted to a solid table or a flat piece of plywood.
I used a 610mm length of this extrusion, bolted to a solid wood desk, and had no problem supporting a 3.5-pound camera and lens combo all the way at the top. There's a bit of vibration; you'll need a remote release and a DSLR should probably use mirror lock-up. Maybe even EFCS if you have the option.
I'm no good with FreeCAD, so I imported TadTadd's work into Onshape; both the original and the base are here.