1 / 2
Cover for MMU hole with hacker board pass through — zdjęcie 1
1 / 2

Cover for MMU hole with hacker board pass through

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Protects electronics after removing MMU cable plug to allow hacker board cable access

Ocena
0 / 5
Polubienia
0
Pobrania
10
Wydruki
0
Wyświetlenia
104
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Public Domain

I used Steve's model https://www.printables.com/model/1016997-prusa-gpio-hackerboard-cover to mount my hacker board to the frame (it's a great model). I removed the “plug” in the cable holder which is normally punched out to connect the MMU cable. Since I don't have an MMU this left a  gap from the top into the electronics enclosure and I considered it a risk. 

I designed this small “plug” to fill that gap. I printed it using Fiberlogy FiberFlex 40D filament so it is a friction fit. It can be installed from the top with a bit of finger pressure. If you have trouble you could loosen the two screws on the side of the bracket when you insert the plug then tighten them back up.

Tagi