Elegoo Mars 5 Ultra Bed Leveling Standoff Spacer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Standoff for bed-level paper calibration.
- Ocena
- 5 / 5
- Polubienia
- 13
- Pobrania
- 88
- Wydruki
- 1
- Wyświetlenia
- 1158
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Simple little standoff spacer to help level your bed. My spring-loaded bed was way off in one corner.
Usage:
Remove OEM bed screws. Replace with new set screws. Tighten till bottoming out in the threaded hole. Install the spacer over the set screw with the opening downward. Install the lock nut over the spacer. <a small washer might be helpful between the spacer and nut>
I made an SLA print file to test the level. 1s exposure and 120s until lift. This gives me 2 minutes to play with the adjustments.
Paper too loose = Nut goes up
paper too tight = Nut goes down
It is best to restart the test file after several adjustments, keeps everything on track.
Parts needed:
- 4x printed standoffs
- 4x M4 x 25-30mm set screw
- 4x M4 nylon lock nut.
This should be a “set it and forget it” mod. Time will tell….
Your mileage may vary.