Powerbank case holder with belt loop
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple way to attach a powerbank on a belt
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 164
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- BSD License
Powerbank case holder belt loop
A simple powerbank holder which can attach to a belt for when you need more security than a clip.
Great for videographers or hooking electronics up to power for costumes.
Holds most 10.000 mAh powerbanks with max size of: 8cm x 3cm x 15cm
If your powerbank is smaller, add in a bit of cheap foam on all sites so that it doesn't rattle.
Max belt width is 4.5cm and a thickness of 0.5cm
It's deep enough where it protects the connectors from bumping against things.
Make sure to print outer edges first.
Enable supports but disable auto supports.
Then draw 4 or 5 dots on the bottom of the part that holds the belt.
You don't need supports in the loop where the belt comes through.
With three different optional end caps
- Cap (as shown in image to expose multiple ports)
- Cap Small (smaller hole)
- Cap closed (no hole to protect somewhat against the elements).
Print outer edges first in order to get a proper fit!
The cap will not hold when holding it upside down with the powerbank in it.
Modeled in OnShape, printed on Prusa Mini+