Energy drink can holder (⌀ 54 mm) for bed/sofa (prevent accidental spill)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Sip a can of energy drink in the morning without spilling it while you are still half asleep. :)
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 168
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bedroom
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Ever worried about accidentally spilling your morning energy drink on your mattress while you are still half asleep? Or spilling your drink on the armrest of your sofa while you watch the game? The worry is over. This printable model may be what you need.
I printed it in alternating black and white. Bottom part in black so that it's better visible on my white mattrass. Middle part is white, but the top layers are black again for the same reasons.
These are some of the print settings I used:
- Layer height: 0.2 mm
- Print speed: 60 mm/s
- Initial layer speed: 40 mm/s
- Z Hop speed: 5 mm/s
- Enable retraction with distance: 0.8 mm
- Z Hope when retracted
- Fan speed: 100%
- Initial fan speed: 0%
- Adhesion: Raft
- Raft top layers: 0
- No supports
- Infill: Cubic, 10% (doesn't matter much)
- Pause AFTER layer: 13 and 226 (for filament change)
- Material: PLA
With my print settings, provided variant 1 and variant 2 should require approximately 32 g and 30 g of PLA respectively.
The time is around 3 hours and 20 minutes.
