Tablet/Phone Holder for Zwift Ride

This tablet/phone mount is for the Zwift Ride stationary bike. It is very sturdy. The long clamp opens up 255mm (10in), and the normal clamp opens up to 230mm (9in). No additional hardware is required. For detailed installation instructions please see the attached documentation under Other Files.

You could used any filament. My personal one is out of plane jane PLA. PETG, ABS, or ASA would probably be better though. 

As for print settings, I'd do at least 4 walls, especially for the Tray because the self tapping screws attach to it. 

The stls should insert into your slicer in the correct orientation for printing. The tray and clamp bottom require support. Make sure the support is cleaned up well before trying to assemble. Some filing may be required to make the parts fit. Clamp bottom has some built in support that should easily break away.

I've been working on additions like a towel holder and a power block/charging station holder. Both will likely only replace the base so no other parts will have to be reprinted. 

Enjoy.

Edit 3-22-26: Added longer top clamp and screw to accommodate larger devices. 

Edit 10-7-26: Added shorter bottom clamp, bottom clamp and screw for use with phones in landscape mode. Should work with phones around 66-100mm wide.