TP Link EAP610 Outdoor Access Point EAP Stand and Wall Bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Table and wall mount for the above using vertical slide mount
- Ocena
- 5 / 5
- Polubienia
- 9
- Pobrania
- 100
- Wydruki
- 1
- Wyświetlenia
- 501
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Share Alike
Both use the tabbed pole mount on the rear of the EAP allowing it to drop into the bracket.
One is a simple wall mount, the other is a freestanding table top stand with cable routing for 6mm diameter cable through the base. Cut out allows good bend radius.
Since taking the photos I have extended the slide 4mm so the end of the bracket does not show when viewed from the back.
Printed without support in PLA+, layer height 0.22, 4 perimeters, 25% grid infill up to where the stand narrows narrow above the cable cut out then used a modifier slab to change to 50% infill for the narrow vertical. Seems plenty strong enough for the task.
Fan set to 10% for extra layer adhesion (only slight sag in the bridge at the top of the cable cut out but not visible)
Reduced speed to 75% about half way up as I was getting a bit worried about the vibrations in the tall thin section with high travel speed.
From memory it used about 140g of filament.