8mm Thru Hull Box connection for brushless motor

I made these to connect my brushless motors to a waterproof case that houses my speed controllers and battery with 10awg wires and 8mm bullet connectors. I personally print in ASA, but I also adjusted the sizing for PETG and the files are labeled as such. There is a mold that I use 2 part silicone to form a gasket. There is also a nut to secure the the connector on the inside. After inserting the wires and connectors that are soldered I poor epoxy in the back to provide the waterproofing. On the female box side, make sure you fill it completely to help provide support for the threads. For the connection, there is nothing to secure the plug and there is a small gap that I fill with dielectric grease to protect the bullet connectors from moisture. I have been running these for a few months without any issues in the salt water. I print with 100% infill. Use at your own risk and test the water tightness of the box before installing any other electronics/batteries. The bullet connectors I use are from amazon and are the LINSYS 8mm bullet connectors. I have no affiliation, but if you get a different connector, the sizing might be slightly off.