Passthru for 4" ducting
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Used to connect 4" vent line through an enclosure wall (acrylic, plywood, etc...)
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 198
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Print two of these to pass 4" ducting (Like the AC Infinity 4" ducting I used) through an enclosure wall for a 3D printer, laser etcher, etc… There are grooves to put adhesive foam tape in for a better seal; the foam tape stands slightly proud of the surface to be compressed via 4x M3 screws. The holes are interference holes for M3 screws (length will depend on your enclosure material).
- 60' Adhesive Foam Tape 1/4"Wx1/8"D: https://amzn.to/4h8z24B
- AC Infinity CLOUDLINE PRO T4 Inline Duct Fan: https://amzn.to/3CnpWC4
- AC Infinity Flexible 4-Inch Aluminum Ducting: https://amzn.to/4h63zQv
- 4" Holesaw for plywood or acrylic: https://amzn.to/4ga3NVG
This was used in conjunction with a 7.5" HEPA filter holder:
Print Profile:
I printed these out of PLA with 3 walls, 3 top shells, 3 bottom shell, 15% grid infil and they came out pretty much one solid piece of plastic. After 5mo of use, I'm uploading this as a success.
No supports were necessary. Overall, fairly easy/benign print.
Those are affiliate links above. I support your freedom to use them and help me pay for filament, or not. Thanks for reading !