Mario Sunshine Shine Sprite FULLY push-pin assembled (NO supports, glue or hardware!)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mario shine sprite, easy to assemble with push-pins.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 50
- Wydruki
- 0
- Wyświetlenia
- 201
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial
I split the model into parts to allow for easy non-support printing and push-pin assembly.
This model was chosen to be as accurate as possible to the shine model, and as easily printabe as possible to prevent blemishes and waste from supports. When fit properly, there is no need for glue or hardware to connect everything, just print the pieces in the colour you desire.
You will need 3 pushpins and 2 eyes, the 3mf file contains everything needed. Please separate the eyes to print in another colour.
Pic printed at 0.2mm, 3 walls, no brim or support.
Just note that you will need to ensure your seams are calibrated VERY smooth, any protruding bumps may result in a very hard time fitting the pieces. The tolerances are fairly tight and the pieces are small, so if your eyes and pegs don't fit it is very easy to play with the scale and try again with minimal effort or time wasted.