Kindle Oasis 9 and 10 TPU Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Print out of TPU suggested to use 3mf file for supports as they are required and hard to remove. Tested on oasis 9-10
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 29
- Wydruki
- 0
- Wyświetlenia
- 190
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Share Alike
This model was made when i realized no one had made an fully fledged case for the kindle oasis yet so i hopped on solid-works and cooked this up, this is compatable with the moko strap for the back of the case. Included 3mf file has straight lines for the tpu supports that i found neccicary and support blocks the entire inner rim as i made that printable without supports with a chamfer(i forgot the number of degrees but its small and shouldnt ruin the print int he overhang dosnt look good) Support material is a pain in the butt to get off but a lot easier with strait lines use an xacto knife to remove the tpu support material interface or remove the entire layer of strait back and forth lines by cutting on either side with an xacto knife and useing pliers or flush cutters to pull the layers off. If you want you can paint fuzzy skin on the outside of it for some grip. I used 85a Tpu but you can likely make this out of pretty much any durometer